gordonshop 704-325-0667

Go Kart

Murray frame

Measurements from back of seat to foot peddles adjust from 35"-43"
Measurements from front bumper to rear bumper is 80"
Width from outer rear tires are 46"

New Predator 8hp OHV 301cc engine : cranks easily, runs strong and smoothly

New 40 series torque converter : new belt, aligned properly, smooth operation, high torque, about the fastest one we've rebuilt

New drive chain with straight alignment from clutch gear to axle sprocket

Rear axle bearings greased and in good operable condition; front wheel axles have grease fittings and are grease packed; tires have minor dry rot but tubes are installed and hold air

New on-off toggle switch and wiring

Seat bottom and back are newly built

Frame is primed/repainted

Over all condition : very nice, ready to roll, recommended for terrains with large turning radius

$800 cash

__________________________________________________________________________________________________________

"SOLD"

Little red go kart

Live axle

Please note : measurements from the seat back to the foot peddle is just 28", so this is a  relatively short go kart. However, due to high torque, 6" wheels, and high top end, this small kart is "NOT" a beginner kart, nor is it suitable for inexperienced drivers in the least. Uncomfortable for a taller rider

Torn down, primed/painted, all points greased/lubed

New Predator 212cc 6.5hp OHV engine : cranks easily, runs strong and smoothly

New steering wheel

New throttle cable

New kill switch

New rear wheel bearings, front ones are lubed

New centrifugal clutch

New drive chain

Sprocket/clutch/chain alignment true

Good brake, new brake rod, reconfigured for smooth operation

Original seat in very nice condition

Original tires hold air all around with very good tread

Very low frame clearance, best on hard top or very even ground

Over all condition : nice, ready to roll

$600 cash : price is firm "SOLD"

__________________________________________________________________________________________________________

Unique ride on hybrid

Custom built sometime in the past by someone with extra ordinary skills

Briggs 8hp flathead engine : cranks easily, runs strong and smoothly

Forward, neutral, reverse gears, twist throttle on right handle for speed, hand brake on left handle to stop...both work nicely

Electric start with new starter, new battery

Head/valve job performed with new head gasket, new spark plug, fresh oil change, coil/magneto cleaned/set, cylinder is score free

Carburetor is cleaned with new needle valve/intake gasket/air filter/pre-filter

Appropriate gas tank added with fresh ethanol free gas, new fuel lines/fuel filter/shut off valve

Restricted steering radius on left turns, slightly greater steering radius on right turns

Top speed...perhaps 2-4 miles per hour, so not fast

Due to exhaust pipe added instead of muffler, it does have some loudness

Good drive belts, smooth operation

May be good for tractor shows, parades, or personal use around the homestead

Front weights welded to the front as it will pop wheelies easily

Over all condition : serviced, checked out completely, modified here and there for added stability and assurance of operation, ready to roll

Asking $400 cash

_________________________________________________________________________________________________________

Red go kart

Dead axle : one wheel pull

New Predator 212cc 6.5hp engine : cranks easily, runs strong, idles smoothly

New clutch with 41pitch sprocket

New 4" brake band

New 41 roller chain

New throttle cable

New on/off switch

New home made seat

New tires/tubes all around

New grip tape on foot rest

Kart is disassembled, primed/painted

Bearings replaced or greased all around

All areas brushed out/cleaned

Over all condition : nice, like new, ready to roll

$700 cash